API src

Found 18027 results.

Similar terms

s/o2/O3/gi

Other language confidence: 0.7252224870550382

Luftdaten Deutschland API | Air Data Germany API

Mehrmals täglich ermitteln Fachleute an Messstationen der Bundesländer und des Umweltbundesamtes die Qualität unserer Luft. Schon kurz nach der Messung können Sie sich über die Luftdaten-API die aktuellen Messwerte abrufen. Zurzeit sind Daten ab dem Jahr 2016 abrufbar. Bitte beachten Sie, dass es sich bei den Daten des laufenden Jahres um noch nicht endgültig geprüfte Daten handelt. Erst im Juni des Folgejahres werden die finalen Daten bereitgestellt. Die aktuellen Daten können Lücken aufgrund Übertragungsproblemen enthalten. Das UBA kann keine Vollständigkeit garantieren. Unterjährig erfolgen Updates mit vorläufig geprüften Daten.

GTS Bulletin: QWNM98 EDZW - Pictorial information regional (Binary coded) (details are described in the abstract)

The QWNM98 TTAAii Data Designators decode as: T1 (Q): Pictorial information regional (Binary coded) T1T2 (QW): Wind A1 (N): Northern hemisphere A2 (M): 36 hours forecast T1ii (Q98): Air priorities for the Earth's surface (Remarks from Volume-C: (COSEU) Maxwind 10 m, H+30,+36 (gpv))

GTS Bulletin: IUSD13 EDZW - Observational data (Binary coded) - BUFR (details are described in the abstract)

The IUSD13 TTAAii Data Designators decode as: T1 (I): Observational data (Binary coded) - BUFR T1T2 (IU): Upper air T1T2A1 (IUS): Radiosondes/pibal reports from fixed land stations (entire sounding) A2 (D): 90°E - 0° northern hemisphere(The bulletin collects reports from stations: 10771;Kümmersbruck;) (Remarks from Volume-C: high resolution 2 sec.)

Sentinel-5P TROPOMI - Aerosol Optical Depth (AOD), Level 3 - Global

Aerosol optical depth (AOD) as derived from TROPOMI observations. AOD describes the attenuation of the transmitted radiant power by the absence of aerosols. Attenuation can be caused by absorption and/or scattering. AOD is the primary parameter to evaluate the impact of aerosols on weather and climate. Daily AOD observations are binned onto a regular latitude-longitude grid. The TROPOMI instrument onboard the Copernicus SENTINEL-5 Precursor satellite is a nadir-viewing, imaging spectrometer that provides global measurements of atmospheric properties and constituents on a daily basis. It is contributing to monitoring air quality and climate, providing critical information to services and decision makers. The instrument uses passive remote sensing techniques by measuring the top of atmosphere solar radiation reflected by and radiated from the earth and its atmosphere. The four spectrometers of TROPOMI cover the ultraviolet (UV), visible (VIS), Near Infra-Red (NIR) and Short Wavelength Infra-Red (SWIR) domains of the electromagnetic spectrum. The operational trace gas products generated at DLR on behave ESA are: Ozone (O3), Nitrogen Dioxide (NO2), Sulfur Dioxide (SO2), Formaldehyde (HCHO), Carbon Monoxide (CO) and Methane (CH4), together with clouds and aerosol properties. This product is created in the scope of the project INPULS. It develops (a) innovative retrieval algorithms and processors for the generation of value-added products from the atmospheric Copernicus missions Sentinel-5 Precursor, Sentinel-4, and Sentinel-5, (b) cloud-based (re)processing systems, (c) improved data discovery and access technologies as well as server-side analytics for the users, and (d) data visualization services.

Ozon Fehmarn 1-Stunden Mittelwert 2026

Um die Gesundheit der Menschen und die Vegetation vor den Einflüssen zu hoher Luftschadstoffbelastungen zu schützen, wird die Luftqualität laufend untersucht und nach gesetzlichen Vorschriften beurteilt. Dafür betreibt das Landesamt für Umwelt (LfU) in Schleswig-Holstein ein Netz aus Messstationen, an denen mit unterschiedlichen Methoden Luftschadstoffe gemessen werden. Die Messdaten aus Schleswig-Holstein und viele zusätzliche Informationen zu den Messungen werden an das Umweltbundesamt weiter geleitet und von dort gemeinsam mit den Daten aller Bundesländer an die Europäische Kommission gemeldet. Alle aktuell veröffentlichten Daten sind als ***vorläufig*** einzustufen, da sie zu Ihrer schnellen Information zunächst automatisch auf Gültigkeit geprüft werden. Vor der abschließenden Bewertung und Beurteilung der Luftqualität findet später eine mehrstufige Prüfung nach gesetzlichen Vorgaben statt. Bei den CSV-Dateien „fehlt“ am Tag der Umstellung von Normalzeit (MEZ) auf Sommerzeit (MESZ) die 3-Uhr-Messung, am Tag der Umstellung von Sommer- auf Normalzeit gibt es hingegen zwei 3-Uhr-Messungen. Die JSON-Dateien sind von dieser Problematik nicht betroffen, hier wird durchgängig Normalzeit verwendet. [Informationen zur Messstation](https://www.schleswig-holstein.de/DE/Fachinhalte/L/luftqualitaet/Messstationen/Fehmarn.html)

CO2 and CH4 fluxes before and after rewetting (Table 2)

CH4 and CO2 fluxes (stations 0-7) were calculated from online gas concentrations measurements using laser-based analyzers and manual closed chambers (Livingston, GP, & Hutchinson, G, 1995). Blackwell Science Ltd., Oxford, UK).

Bottom water data of sediment incubation experiments under anoxic conditions

Enhanced mineral dissolution in the benthic environment is currently discussed as a potential technique for ocean alkalinity enhancement (OAE) to reduce atmospheric carbon dioxide (CO2) levels. This study explores how biogeochemical processes affect the dissolution of alkaline minerals in surface sediments during laboratory incubation experiments. These involved introducing dunite and calcite to organic-rich sediments from the Baltic Sea under controlled conditions in an anoxic to hypoxic environment. The sediment cores were incubated with Baltic Sea bottom water. Eight sediment cores were positioned vertically in a rack. Since the sediment surface was slightly oxidized by the bottom water (∼125 μmol l−1 upon recovery), the cores were left plugged on the top for 13 days to settle after recovery until the sediment surface was anoxic. To achieve chemical conditions that are expected in the natural system, 500l of retrieved sea water were degassed via bubbling with pure dinitrogen gas in batches of 100 l. Afterwards, between 50 and 60 l were transferred into an evacuated gas tight bag. After the transfer, pH and total alkalinity (TA) were measured to determine the dissolved inorganic carbon (DIC) of the water. Afterwards the DIC was increased via adding pure CO2 until a CO2 partial pressure (pCO2 ) of ∼2,300–∼3,300 μatm was established mimicking conditions prevailing in Boknis Eck during summer. Stirring heads were installed on the cores. To prevent the development of oxic conditions, it was ensured that as little gas phase as possible was left in the cores. Elimination of pelagic autotrophs, heterotrophs, and suspended particles was achieved by flushing the cores with modified bottom water for 2 days with a flow rate of 1.5 mml min−1. Afterwards, a continuous throughflow of 700 μl min−1 from the reservoir of modified bottom water was applied, leading to a residence time of ∼2.1 days inside the cores. For the experimental incubations, six cores received additions of alkaline materials, three with calcite (Cal1 - Cal3) and three cores with dunite (Dun1 - Dun3), leading to three replicates per treatment. Two control cores remained untreated (C1, C2). The amount of added substrate was based on the rain rate of particulate organic carbon observed in Boknis Eck (0.5 mmol cm−2 a−). The incubation lasted for 25 days. The volume of water in each core was determined at the end of the experiment via measuring the height of the water column after removing the stirring heads. Bottom water samples were taken from the outflow of each core over a time period of several hours. Thus, samples represent the average outflow over the respective time period. Sampling intervals increased from daily during the first two weeks to every three to four days and weekly towards the end of the experiment. All samples were filtered through a 0.2 µm cellulose membrane filter and refrigerated in 25 ml ZinsserTM scintillation vials. Samples for TA were analyzed directly after sampling by titration of 1 ml of bottom water with 0.02N HCl. Titration was ended when a stable purple color appeared. During titration, the sample was degassed by continuous bubbling with nitrogen to remove any generated CO2 and H2S. The acid was standardized using an IAPSO seawater standard. Acidified sub-samples (30 μl suprapure HNO3- + 3 ml sample) were prepared for analyses of major and trace elements (Si, Na, K, Li, B, Mg, Ca, Sr, Mn, Ni and Fe) by inductively coupled plasma optical emission spectroscopy (ICP-OES, Varian 720-ES).

Organic parameters obtained from Metzingen core

The total carbon (TC), total organic carbon (TOC), and total sulfur (TS) were determined using a LECO CS-230 system (Laboratory Equipment Corporation). Samples were heated up to 2000 °C under an oxygen atmosphere and an infrared detector subsequently measured the amount of produced CO₂ and SO₂. TOC was measured the same way after removing inorganic carbonates using 10 % HCl solution at 80 °C. Rock-Eval Pyrolyses were performed on a Rock-Eval-6 analyser (Vinci Technologies) using up to 180 mg initial sample material and a standard program (Espitalié et al., 1977; Lafargue et al., 1998), starting isothermal with 300°C for 3 min, succeeded by a heating rate of 25°C/min up to 650°C. Standard deviations for hydrogen indices (HI) and Tmax values are ± 5 % and ± 2°C, respectively.

Organic parameters obtained from Röttingen core

The total carbon (TC), total organic carbon (TOC), and total sulfur (TS) were determined using a LECO CS-230 system (Laboratory Equipment Corporation). Samples were heated up to 2000 °C under an oxygen atmosphere and an infrared detector subsequently measured the amount of produced CO₂ and SO₂. TOC was measured the same way after removing inorganic carbonates using 10 % HCl solution at 80 °C. Rock-Eval Pyrolyses were performed on a Rock-Eval-6 analyser (Vinci Technologies) using up to 180 mg initial sample material and a standard program (Espitalié et al., 1977; Lafargue et al., 1998), starting isothermal with 300°C for 3 min, succeeded by a heating rate of 25°C/min up to 650°C. Standard deviations for hydrogen indices (HI) and Tmax values are ± 5 % and ± 2°C, respectively.

Real-time monitoring of CO2-rich mineral waters and mofettes in the Eifel volcanic fields

Real-time fluid monitoring began in late 2020 in the East Eifel and currently includes 12 sites, such as abandoned CO₂ wells, mofettes, CO₂-rich springs, CO₂-rich soil, and a cold-water geyser in the West Eifel. For the first time, fluid data are being recorded continuously with a high temporal resolution of up to 1 Hz. Depending on the local site conditions, the following parameters are being monitored: instrument temperature and battery voltage; barometric pressure and temperature; meteorological parameters; water level, wellhead pressure, water temperature; radon in free gas phase; CO2 concentration and CO2 flux in soil gas. Data are transmitted hourly via FTP to GFZ. While we generally observe small seasonal variations, short-term transients related to heavy rain or local and distant earthquakes are indicated. Over longer periods, we observe trend changes in helium isotope ratios, radon concentration, and water temperature. For example, two sites exhibited significant helium isotope changes from 2021 to 2025, which appear to correlate with earthquake swarms at depth. These examples demonstrate the necessity of jointly interpreting meteorological, hydrogeological, geophysical, and geodetic data.

1 2 3 4 5 … 1801 1802 1803