This dataset provides results from rheological tests of glucose syrup from two suppliers tested within the EPOS Multi-scale Laboratories (MSL) trans-national access (TNA) program 2019 at the Laboratory of Experimental Tectonics (LET), Univ. Roma TRE, Italy. Syrups Glucowheat 45/81 (GW45) and Glucowheat 60/79 (GW60) are produced by Blattmann Schweiz AG, Switzerland (2019 batch). Syrups GlucoSweet 44 (GS44) and GlucoSweet 62 (GS62) are produced by ADEA (Amidi Destrini ed Affini), Italy (2019 batch) . The four tested glucose syrups are labeled according to their DE value (dextrose equivalent value). For tested products from Blattmann Schweiz AG, the second number refers to the weight percentage of dry substance. Glucose syrup GS44 is used in full lithospheric scale analogue experiments at the Tectonic Modelling Lab (TecLab) at the University of Bern, Switzerland as a low-viscosity material simulating the asthenospheric mantle lithosphere to provide isostatic equilibration. The materials have been analyzed using a MCR301 Rheometer (Anton Paar) equipped with parallel plates geometry and rotational regime . To prevent the evaporation of the samples during the measurements, an external water-lock device has been used.
This dataset provides rheometric data of three viscous materials used for centrifuge experiments at the Tectonic Modelling Laboratory of CNR-IGG at the Earth Sciences Department of the University of Florence (Italy). The first material, PP45, is a mixture of a silicone (Polydimethylsiloxane or PDMS SGM36) and plasticine (Giotto Pongo). The PDMS is produced by Dow Corning and its characteristics are described by e.g. Rudolf et al. 2016a,b). Giotto Pongo is produced by FILA (Italy). Both components are mixed following a weight ratio of 100:45, and the final mixture has a density of 1520 kg m3.
The second material, SCA705 is a mixture of Dow Corning 3179 putty, mixed with fine corundum sand and oleic acid with a weight ratio of 100:70:05 and a resulting density of 1660 kg m3. The final material, SCA7020 consists of the same components as SCA705, but with a slightly higher oleic acid content reflected in the weight ratio of 100:70:20. The mixture’s density is 1620 kg m3. The material samples have been analyzed in the Helmholtz Laboratory for Tectonic Modelling (HelTec) at GFZ German Research Centre for Geosciences in Potsdam using an Anton Paar Physica MCR 301 rheometer in a plate-plate configuration at room temperature (20˚C). Rotational (controlled shear rate) tests with shear rates varying from 10-4 to 1 s-1 were performed. Additional temperature tests were run with shear rates between 10-2 to 10-1 s-1 for a temperature range between 15 and 30˚C.
According to our rheometric analysis, the materials all exhibit shear thinning behavior, with high power law exponents (n-number) for strain rates below 10-2s-1, while power law exponents are lower above that threshold.For PP45, the respective n-numbers are 4.8 and 2.6, for SCA705 6.7 and 1.5, and for SCA7020 9.1 and 2.0. The temperature tests show decreasing viscosities with increasing temperatures with rates of -3.8, -1.4 and -1.9% per ˚K for PP45, SCA705 and SCA7020, respectively. An application of the materials tested can be found in Zwaan et al. (2020).